Software Problem

I have a program that works under dos and I am trying to install it under windows 98 everything completes well only that when I try to execute the program I get a wierd message "Runtime Error at 0F2A:0091" this occurs when installing it on a new PC P-III 500 procesor when using my old PC Pentium-MMX 200 it works just fine... is there a program that can reduce the clock speed or something so that this program can work I would be very much obligated.
Thank you

1. RE: Software Problem
lbyard Nov-09-00 02:31 PM
In response to message 0

What is the program? The problem is probably not the difference in speed between the two computers. Does it require a dongle (a device that plugs into the printer port) or other security device? Larry

2. RE: Software Problem
akmour Nov-10-00 09:00 AM
In response to message 1

The program is for drawing mechanical plans but it doesn't need any sort of device on the printer port (hasp,dongle etc.) All I have to do is to install it and modify the autoexec.bat file with some commands it needs. Any thing on your mind ? Apostolis...

3. RE: Software Problem
lbyard Nov-10-00 05:33 PM
In response to message 2

What is in the autoexec.bat file. Other than the lines for this program, what are the differences, if any, between the autoexec.bat on the fast machine and the autoexec.bat on the slow machine? Fishing... Larry

4. RE: Software Problem
akmour Nov-13-00 12:02 PM
In response to message 3

Actually there are no command lines that differ in any way from the ones on the fast machine?
I tried to load a hard disk from dos 6.2 and to run it from there but nothing happend any other thoughts ...
Awaiting your reply...

5. RE: Software Problem
lbyard Nov-13-00 03:53 PM
In response to message 4

LAST EDITED ON Nov-13-00 AT 03:55 PM (GMT)
Suggest looking at c:\windows\programs.txt. Also, considering the type of program you are trying to run, the difference between the computers causing the problem could be the difference in the display adapters. Larry

6. RE: Software Problem
akmour Nov-16-00 09:01 AM
In response to message 5

I looked up the programs.txt and found nothing, I even tried to change the display adapters AGP to PCI but still the same message occurs the program is called SPIRIT it's a clean DOS program

7. RE: Software Problem
lbyard Nov-16-00 05:33 PM
In response to message 6

You took the display adapter out of the computer that works and installed it and it's driver in the computer that does not work? Larry

8. RE: Software Problem
naveen chauhan Dec-23-00 08:49 AM
In response to message 0

after addding new processor reinstall win98 and then install your program it will work fine.